Continued Post :p
Next step, make the entrance hole for tubing.
Make sure the tube has enough length to reach the edge of head position, cut it if necessary
Fill some ink just to make sure that we put correct colour to rhe catridge, place the knee connector
Place every knee connector to its place, responding to its color, full fill the ink tank now, put on a higher place and let the ink flow to the cartridge
Pull of the tip, to release the air inside the cartridge and let the ink flow inside, let them fill slowly, you can stop when it reach at least a half.
When you done, put the cartridge on the head, place the tube figured bellow, tied them up with cable ties
When you've done tied them, move the print head to left and right, mamke sure everything work fine
well, that all for the part two, next ... installing the waste ink ... on the next part off course :p
My place for sharing my practical knowledge on working with printer, hope this information can help others, happy reading... !
Saturday 15 December 2012
Thursday 13 December 2012
Installing CISS on Epson TX 121x - Part 1
In this post I would like to share about installing CISS - Continuous Ink Supply System on Epson TX 121x, this printer type is
most affordable multi function printer of Epson, by installing this CISS we can
easily fill the ink tank.
Preparation
- Printer Itself; CISS Kit & the Ink - Put the box on the left side of the printer, it will be useful for further need.
Dismantling TX 121x Cover
Open the button panel, there is one screw beneath the panel, open the nuts using Phillips Screwdriver
Remove the front cover by pulling the middle part of it, Open nut over there
Open two more screw
Push right hand side body outside - Now we can easily lift up the scanner unit
Lay the scanner unit on the Left BOX
These steps also as a guidance for disassembly , particularly this procedure only takes less than 2 minutes
These steps also as a guidance for disassembly , particularly this procedure only takes less than 2 minutes
Subscribe to:
Posts (Atom)