Next step, make the entrance hole for tubing.
Make sure the tube has enough length to reach the edge of head position, cut it if necessary
Fill some ink just to make sure that we put correct colour to rhe catridge, place the knee connector
Place every knee connector to its place, responding to its color, full fill the ink tank now, put on a higher place and let the ink flow to the cartridge
Pull of the tip, to release the air inside the cartridge and let the ink flow inside, let them fill slowly, you can stop when it reach at least a half.
When you done, put the cartridge on the head, place the tube figured bellow, tied them up with cable ties
When you've done tied them, move the print head to left and right, mamke sure everything work fine
well, that all for the part two, next ... installing the waste ink ... on the next part off course :p
No comments:
Post a Comment